90a.jpg
90B.JPG
90C.JPG
90a.jpg
90B.JPG
90C.JPG

Worksaver Postdriver

$7,000.00
Only 1 item available

Worksaver Postdriver - HPD-26Q

  • This is a 3-point post driver with hydraulic tilt adjustment complete with stabilizer legs, safety arm and hydraulic hoses.

  • The HPD-26Q (110,000 lbs. of force) can drive posts of up to 11” diameter 10’ long.

  • Q-series drivers feature two time savings QuickChange™ system.

  • Worksaver’s SplitCap™ with enhanced cylinder rod design allows the operator to perform routine maintenance on the rod cap seal without removing the cylinder from the driver.

  • Our Q-spring assembly reduces spring change over from hours to minutes.

Purchased new in anticipation of a vineyard - never used.

Add To Cart

Worksaver Postdriver - HPD-26Q

  • This is a 3-point post driver with hydraulic tilt adjustment complete with stabilizer legs, safety arm and hydraulic hoses.

  • The HPD-26Q (110,000 lbs. of force) can drive posts of up to 11” diameter 10’ long.

  • Q-series drivers feature two time savings QuickChange™ system.

  • Worksaver’s SplitCap™ with enhanced cylinder rod design allows the operator to perform routine maintenance on the rod cap seal without removing the cylinder from the driver.

  • Our Q-spring assembly reduces spring change over from hours to minutes.

Purchased new in anticipation of a vineyard - never used.

Worksaver Postdriver - HPD-26Q

  • This is a 3-point post driver with hydraulic tilt adjustment complete with stabilizer legs, safety arm and hydraulic hoses.

  • The HPD-26Q (110,000 lbs. of force) can drive posts of up to 11” diameter 10’ long.

  • Q-series drivers feature two time savings QuickChange™ system.

  • Worksaver’s SplitCap™ with enhanced cylinder rod design allows the operator to perform routine maintenance on the rod cap seal without removing the cylinder from the driver.

  • Our Q-spring assembly reduces spring change over from hours to minutes.

Purchased new in anticipation of a vineyard - never used.

  • Max. Post Size - 8-3/4” x 10’

  • Impact at Full Stroke - 80,000 lbs.

  • Impact at Half Stroke - 40,000 lbs.

  • Mount Type - 3-pt. Cat I/II

  • Tilt Adj. Front/Back - 17° each way

  • Tilt Adj. Side/Side - 20° each way

  • Manual Adjust - No

  • Hydraulic Adjust - Yes

  • Adj. Cylinders/Size - (2) 3” x 6”

  • Stabilizer Legs - Standard

  • Big Foot - Yes

  • Slide Blocks Material - UHMW*

  • Spring Post Holder - Standard

  • Min. Tractor Size - 30-35 hp

  • Rear Hitch Category - Cat. Ior II

  • Min. Hydraulic Req. - 6-8 GPM

  • QuickChange Rod Seal - Yes

  • Q-springs - Yes

  • Valve(s) - Sgl./Dbl. Spool

  • Hoses less couplers - Standard

  • Weight  - 1035 lbs